Durite 0-525-62 LED Illuminated Marine Voltmeter Gauge - 24V
24 volt voltmeter marine gauge, 90° sweep dial 16-32V. LED illumination in either white or yellow, plastic cased and with stainless steel bezel. Screw collar type fitting.
Specification
52mm Dashboard fitting
90° Sweep dial
LED illumination in either white or yellow
Plastic cased and with stainless steel bezel
Protected to IP67 (from the front)
Max panel depth 25mm
600mm cable length
Voltage 16-32V DC
Panel cut out 52mm dia
Protection IP67 (from the front)
Fitting
1. Cut a 52mm (2 1/16 inch) diameter panel hole. Save a minimum of 55mm (2 3/16 inch) of depth behind the panel to fit the gauge.
2. Remove the fastening ring.
3. Fit cables through panel hole and insert connector into back of gauge.
4. Insert gauge through panel from the front, fit and tighten fastening ring from the rear checking the position of the gauge before tightening.
5. Connect cables by following the below instructions.
Gauge
1. Black – to Common Ground (-)
2. Red – to Positive (+)
3. White – for the white backlight (+)
4. Orange – for the yellow backlight (+)
Parcels under 2kg: sent via royal mail with a estimated delivery of 3-5 Working Day
Parcels over 2kg: sent via DPD or Parcel Force - 1-3 Working Days
Free shipping: on orders over £100.00*
Bristol Auto Electrical Van Delivery: Free delivery within the local area. This option is available on checkout based upon the delivery address postcode.
Depending on the item delivery time is same-day to 3 days between 10:00am - 4.00pm. Covering the following postcodes BS, SN, BA, SP, GL, NP, DT, TA
Collection: from our Bristol or Westbury depot.
*Postage surcharges may apply to Scottish Highlands and islands. For more information on delivery and surcharges please see our Delivery Information